|
|
How to Calibrate Home Theater System Speakers
To optimize your home theater system, you should calibrate your speakers to fit acoustically with your home listening environment. Speaker calibration is a relatively simple procedure that shouldn't take more than 20 minutes, and it will change your home audio system's output quality dramatically. Follow these steps to calibrate your home theater system speakers.
Instructions
Step
1
Connect the speakers to the receiver, and then set them up around the room according to the manual instructions. The set-up will depend on your particular system.
Step
2
Set a sound level meter to "C Waiting" and "Slow Response."
Step
3
Position the meter in the spot where you plan to listen from most often, and stand somewhere that isn't between the speaker and the meter. Getting in the way of the meter will give you a bad reading and your home theater speakers will not calibrate properly.
Step
4
Play a movie on your home theater system at normal volume. Playing a movie at an extreme volume will cause an improper calibration.
Step
5
Point the meter at each of the speakers and open the menu. On the menu, there will be options such as "front," "rear," and "side" for each of your speakers. Select the appropriate option for the speaker you are calibrating.
Step
6
Play a test tone on your meter, and adjust the knob until the display reads zero decibels. Repeat this step for each of the other speakers in your system.
Step
7
Adjust your speakers' channels on the receiver to match the readings given to you on the meter. Doing so will ensure optimum performance from your speakers.
Step
8
Adjust your subwoofer to blend in with your speakers by simply sitting in the room and playing around with settings until you've found a satisfactory setup.
copy&paste dari website...
member aku siap panggil technician dtg rumah buat calibration.... |
|
|
|
|
|
|
|
|
|
|
|
Post Last Edit by danedzya at 13-1-2010 00:39
berapa harga ko beli amp tu?? |
|
|
|
|
|
|
|
|
|
|
|
Post Last Edit by danedzya at 13-1-2010 00:39
berapa harga ko beli amp tu??
danedzya Post at 13-1-2010 00:37 
timakasih atas instruction tersebut..cuba nak buat, tapi pening jugak, banyak sangat dia punya buttton kat remote...aku beli Amp tuh 1700 kat JB..rasanya kat KL lagi muurah....naampak nya kena panggil technician kedai tuh tgk kan.. |
|
|
|
|
|
|
|
|
|
| |
|
Post time 13-1-2010 12:33 AM
